Sign in
Search Comp.Arch.FPGA
fpga by Keywords
Altera | ASIC | CPLD | Cyclone | DCM | DDR | DSP | Ethernet | ISE | JTAG | Linux | LVDS | Microblaze | ML310 | Modelsim | NIOS | OPB | PCI | Quartus | RocketIO | SDRAM | Spartan | Spartan3 | SRAM | Stratix | Verilog | VHDL | Virtex | Virtex-4 | Virtex-II | Xilinx | XST
Ads
See Also
Comp.Arch.FPGA | MB debug module
There are 1 messages in this thread.
You are currently looking at messages 0 to 1.
MB debug module - ines_fr - 2010-01-02 07:20:00
I'm working on a multiprocessor architecture
targeting spartan 3 starterkit. (referring to the tutorial XAPP996). I'm stuck in the phase of runimplementation set, because I could not connect the MicroBlaze to the DebugModule "mdm"!!I used XMD debug by typing the command "connect mb mdm",
butthere is an error as follows:
Info: Autodetecting cable. Please wait.
Info: Connecting to cable (Parallel Port - LPT1).
Info: Checking cable driver.
Info: Driver windrvr6.sys version = 8.1.1.0.Info: WinDriver v8.11 Jungo (c)1997
- 2006 Build Date: October 16, 2006 X86 32bit SYS 12:35:07, version =811.
Info: LPT base address = 0378h.
Info: ECP base address = 0778h.
Info: Cable connection established.
JTAG chain configuration
--------------------------------------------------
Device ID Code IR Length Part Name
1 01414093 6 XC3S200
2 05045093 8 XCF02S
ERROR: Could Not Detect MDM Peripheral on Hardware. Check:
1. If FPGA is Configured Correctly
2. MDM Core is Instantiated in the Design
So please, if anyone knows the solution, pleaaase my answer!!I'm stuck
with all my great appreciation!!!
INES
---------------------------------------
This message was sent using the comp.arch.fpga web interface onhttp://www.FPGARelated.com
