Sign in

username:

password:



Not a member?

Search Comp.Arch.FPGA



Search tips

fpga by Keywords

Altera | ASIC | CPLD | Cyclone | DCM | DDR | DSP | Ethernet | ISE | JTAG | Linux | LVDS | Microblaze | ML310 | Modelsim | NIOS | OPB | PCI | Quartus | RocketIO | SDRAM | Spartan | Spartan3 | SRAM | Stratix | Verilog | VHDL | Virtex | Virtex-4 | Virtex-II | Xilinx | XST


Ads

See Also

DSPEmbedded SystemsElectronics

Comp.Arch.FPGA | Spartan 2 & 3, serial config and CS pin

There are 2 messages in this thread.

You are currently looking at messages 0 to 2.

Spartan 2 & 3, serial config and CS pin - aleksa - 2010-05-16 05:56:00

Spartan 2 docs clearly says that, even though
you are configuring the FPGA in serial mode,
you should keep CS pin high.

What about Spartan 3?

I don't see something like:
"Yes, Spartan 2 had an error, but it has been fixed in Spartan 3"



Re: Spartan 2 & 3, serial config and CS pin - aleksa - 2010-05-18 14:57:00

"aleksa" <a...@gmail.com>
wrote in message news:hsofgj$mrk$1...@news.eternal-september.org...
> Spartan 2 docs clearly says that, even though
> you are configuring the FPGA in serial mode,
> you should keep CS pin high.
>
> What about Spartan 3?
>
> I don't see something like:
> "Yes, Spartan 2 had an error, but it has been fixed in Spartan 3"
>
>

OK, when I build my board, I will toggle CS pin (with active WR)
during serial config and will write here.