Reply by Thomas Bornhaupt●October 14, 20032003-10-14
Hi I had the same with an EPC2. Take a closer look to the routing of the
TDO-Line. This line has no pullup or -down resitor. So this was my problem.
The TDO-line was to close and to long by an other clock line.
i hope it helps.
Thomas
"Steven" <sleischo@scires.com> schrieb im Newsbeitrag
news:c3cc9b26.0310130613.6f053388@posting.google.com...
> I have a design with a JTAG chain consisting of APEXII, EPC16UC88,
> MERCURY, EPC16UC88.
>
> I have built the design 3 previous times and been able to program my
> boards, no problems.
>
> Now I have 3 boards, one works fine, one will not accept a .POF file
> into the second EPC16 part, and the third will not accept a .POF into
> either of the EPC16 parts.
>
> What happens is Quartus starts erasing the part and after about 45
> seconds kicks out with an error "Error Operation Failed"
>
> I would think I have a bad part, but that would mean I have 3 bad
> parts out of six (and they are ball grids so not easy to swap out).
>
> I think the JTAG chain is OK, I can do .SOF programs and everything
> works great.
>
> Any ideas on what else to check or try, or could I have a batch of bad
> parts????
>
> I have tried this under Quartus 2.8 and 3.0. I have also tried using
> a jam file under MaxPlus 10.2. I have tried it with different length
> cables from my parallel port, I have tried it with different Byte
> Blasters, and on different computers.
>
>
>
> Thanks
Reply by Steven●October 13, 20032003-10-13
I have a design with a JTAG chain consisting of APEXII, EPC16UC88,
MERCURY, EPC16UC88.
I have built the design 3 previous times and been able to program my
boards, no problems.
Now I have 3 boards, one works fine, one will not accept a .POF file
into the second EPC16 part, and the third will not accept a .POF into
either of the EPC16 parts.
What happens is Quartus starts erasing the part and after about 45
seconds kicks out with an error "Error Operation Failed"
I would think I have a bad part, but that would mean I have 3 bad
parts out of six (and they are ball grids so not easy to swap out).
I think the JTAG chain is OK, I can do .SOF programs and everything
works great.
Any ideas on what else to check or try, or could I have a batch of bad
parts????
I have tried this under Quartus 2.8 and 3.0. I have also tried using
a jam file under MaxPlus 10.2. I have tried it with different length
cables from my parallel port, I have tried it with different Byte
Blasters, and on different computers.
Thanks