mughat wrote:

> Anyone have experience with designing band pass filters for ACTEL FPGAs? 
> Tools, appnotes anything is of interest.
> 
> I my project I have to make some DSP on 3 audio signals (100Hz-22Khz). 
> Planing on using the new Fusion mixed-signal FPGA from ACTEL.
> 
> 

You need to design the filter first using some filter design software 
(this will give your the filter architecture and coefficients).  Then 
you can worry about putting into the device.  You don't say much about 
your requirements or environment.  Audio sample rates are much lower 
than what modern FPGAs can be clocked at, so it is perfectly reasonable 
to use a combination of bit serial and time-multiplexed logic to reduce 
the footprint of your filter.

Anyone have experience with designing band pass filters for ACTEL FPGAs? 
Tools, appnotes anything is of interest.

I my project I have to make some DSP on 3 audio signals (100Hz-22Khz). 
Planing on using the new Fusion mixed-signal FPGA from ACTEL.