"Amontec Team, Laurent Gauch" <laurent.gauch@amontecDELETEALLCAPS.com> wrote in message news:<3FF94EAF.7070305@amontecDELETEALLCAPS.com>...
> chi wrote:
> > Hello,
> >
> >
> > I need to program CoolRunner CPLD using an embedded controller. How to
> > set the CPLD registers to work in the ISP mode?
> >
> > Please explain how to do.
> >
> > Regards,
> > Chi
> just put PORT_EN pin to '1' !
>
> Laurent Gauch
> www.amontec.com
1. In My design PORT_EN pin is connected to ground. Is it possible to
enable ISP mode through instruction ISPEN command?
thanks and regards
Chi
Reply by Amontec Team, Laurent Gauch●January 5, 20042004-01-05
chi wrote:
> Hello,
>
>
> I need to program CoolRunner CPLD using an embedded controller. How to
> set the CPLD registers to work in the ISP mode?
>
> Please explain how to do.
>
> Regards,
> Chi
just put PORT_EN pin to '1' !
Laurent Gauch
www.amontec.com
Reply by chi●January 5, 20042004-01-05
Hello,
I need to program CoolRunner CPLD using an embedded controller. How to
set the CPLD registers to work in the ISP mode?
Please explain how to do.
Regards,
Chi