I'm working with a Xilinx board (Spartan XC3S2000) and I can't program Flash Eprom. I'm using iMPACT software. I have generated a configuration file for Eprom and I load it on Eprom. But it doesn't work. When I disconnect my parallel cable IV and set jumpers, my board does not read eprom program. Can someone help me please? How have I to set jumpers?
Xilinx Prom programming
Started by ●May 5, 2005
Reply by ●May 5, 20052005-05-05
finding old archives might help you. i think there had been some relevant discussions in past on this topic. regards, $hreya$
Reply by ●May 6, 20052005-05-06