Dear I need to simulate my EDK (8.2) project. Simulator is Modelsim SE 6.1c. I did following steps: ------------------------------------------- In order to compile COMPXLIB, I used the EDK simulation library compilation wizard Project -> Project options -> HDL and Simulation -> Simulation library path EDK library = C:/EDK/EDK_LIB Xilinx library = C:/Xilinx/Xilinx_LIB ------------------------------------------- However, I could not proceed, because of the message "Modelsim is not found. Please ensure that the simulator is correctly installed and/or necessary environment settings are available". Could anyone tell me "how to set up the environment" (or, how to points to the location of the simulator)? in EDK 8.2 ? Thank you in advance
[EDK tool] simulation setup
Started by ●November 12, 2007
Reply by ●November 12, 20072007-11-12
Pasacco wrote:> Could anyone tell me "how to set up the environment" (or, how to > points to the location of the simulator)? in EDK 8.2 ?Click up a shell, bash or cmd.exe mkdir play cd play vcom If this doesn't give you the vcom usage, type "exit" to close the shell, find vcom, and add it's location to your path and try again. -- Mike Treseler