VirtexE LVDS driver

Hi to all,

I am confused about one thing that if I want to use LVDS in VirtexE,
should I feed the Vcco of the desired bank with 2.5 V. Is it
applicable if I feed the bank by 3.3 V? What about playing with the
termination resistors? I couldn't find a satisfactory answer through
searching but only XAPP232 Appendix A was a bit helping.

Thanks in advance.

Enes

>...I want to use LVDS in VirtexE...2.5V...3.3V...

The was a discussion in this group in December 2007:  "Using LVDS_25
with 3.3V Vcco".