Hi all, From the datasheet of 3c120 (cyclone III), the data[0] is a pin used in configuration, and in user mode it can be used as a dedicated input pin with "optional user control". But when I use it as an input pin in my design, the fitter reports an error saying this pin has been used. Is there any settings I should set before I can use this pin in user mode? Thanks, Hua
DATA0 pin in Cyclone III device
Started by ●May 30, 2008
Reply by ●May 30, 20082008-05-30
On May 30, 10:06 am, Hua <Tommy...@gmail.com> wrote:> Hi all, > > From the datasheet of 3c120 (cyclone III), the data[0] is a pin used > in configuration, and in user mode it can be used as a dedicated input > pin with "optional user control". But when I use it as an input pin in > my design, the fitter reports an error saying this pin has been used. > Is there any settings I should set before I can use this pin in user > mode? > > Thanks, > HuaIn the Device and Pins menu, Dual-Purpose Pins tab (Setting->Device->Device and Pins Options->Dual-Purpose pins.) there's an option forwhat this pin should be after configuration. My guess is that you need to set this. G.