Hello, Could any body tell me if i can use a OPB ethernet device in polled mode for sending and in interrupt mode for receiving packets from the network. I am unable to do that. Why i am asking this? : When i use the ethernet ports in interrupt mode ( i have two of them), due to the priority i set in the interrupt controller, one of the ports always has a higher priority. Because of this the FPGA if it wants to send data using the busy port, it is not able to do so, since the port is held by the interrupt controller. An early reply would be really appreciated. Best regards, G Aswin
Ethernet and Interrupts in Virtex II pro
Started by ●September 16, 2008