Spartan 2 docs clearly says that, even though you are configuring the FPGA in serial mode, you should keep CS pin high. What about Spartan 3? I don't see something like: "Yes, Spartan 2 had an error, but it has been fixed in Spartan 3"
Spartan 2 & 3, serial config and CS pin
Started by ●May 16, 2010
Reply by ●May 18, 20102010-05-18
"aleksa" <aleksazr@gmail.com> wrote in message news:hsofgj$mrk$1@news.eternal-september.org...> Spartan 2 docs clearly says that, even though > you are configuring the FPGA in serial mode, > you should keep CS pin high. > > What about Spartan 3? > > I don't see something like: > "Yes, Spartan 2 had an error, but it has been fixed in Spartan 3" > >OK, when I build my board, I will toggle CS pin (with active WR) during serial config and will write here.