Hi Roland,
You can do this easily with Quartus II 4.0 and later. The steps are
listed below.
1. Open a command line / DOS prompt. Make sure that quartus_cdb is in your
path. Then:
2. cd to the project directory
3. Type
quartus_cdb <project> --update_mif
4. Then type
quartus_asm <project>
In both cases replace <project> with the project name. The command in Step 3
will take the changed mif's and update the compiler database, without
recompiling the rest of the design. The commmand in Step 4 will regenerate
the pof/sof with the new mif.
Hope this helps.
Subroto Datta
Altera Corp.
"roland voraberger" <me@privacy.net> wrote in message
news:2kt63iF66k01U1@uni-berlin.de...
> hello!
>
> i want to compile a design for a altera acex or cyclon and i want to
> put additionally a table into it (f.e. a .mif file) without compiling
> it completely when changing the mif file (each delivered device has its
> own mif file or sth similar)
> what is the best way. does quartus have a possibility while burning to
> integrate the mif file into the pof file while burning?
> or should i use a enhanced configuration device and i must write a
> complete engine to read and write eth out of this device?
> or is it the best way to put simply an flahs onto the pcb?
> best regards, roland
>
> --
> reply me to madcapATsbox.tugrazDOTat
Reply by roland voraberger●July 5, 20042004-07-05
hello!
i want to compile a design for a altera acex or cyclon and i want to
put additionally a table into it (f.e. a .mif file) without compiling
it completely when changing the mif file (each delivered device has its
own mif file or sth similar)
what is the best way. does quartus have a possibility while burning to
integrate the mif file into the pof file while burning?
or should i use a enhanced configuration device and i must write a
complete engine to read and write eth out of this device?
or is it the best way to put simply an flahs onto the pcb?
best regards, roland
--
reply me to madcapATsbox.tugrazDOTat