continuing the discussion about Lattice's DSP block, I found the
following interesting article:
http://www.fpgajournal.com/articles/20040706_lattice.htm
regards,
paul
Luc Braeckman <luc.braeckman@pandora.be> wrote in message news:<lodne0lvp5eovdjm6v670bcrm4uod7vs1i@4ax.com>...
> Joseph,
>
> I tried the software, and it looks good. As you mentioned, they share
> a similar GUI, even the EPIC editor is similar.
> Of course the libraries aren't complete yet, but it gives you a good
> feeling of the possibilities.
>
> You're right, with the introduction of the 90nm SC parts, I think they
> can compete with every other high-end FPGA.
>
> Luc
> ___
>
> On Tue, 6 Jul 2004 21:18:17 +0000 (UTC), jhallen@TheWorld.com (Joseph
> H Allen) wrote:
>
> >Have any of you tried Lattice's software for their new -EC parts? How close
> >is it to Xilinx (they share a common heritage)? I'm trying to get a feel
> >for its quality and stability.
> >
> >Things should be getting interesting when their 90nm -SC parts come out (vs.
> >Stratix-II and Virtex-4), especially with their cool DDR I/O interface.
> >Perhaps Lattice will make a come-back?
Reply by Luc Braeckman●July 7, 20042004-07-07
Joseph,
I tried the software, and it looks good. As you mentioned, they share
a similar GUI, even the EPIC editor is similar.
Of course the libraries aren't complete yet, but it gives you a good
feeling of the possibilities.
You're right, with the introduction of the 90nm SC parts, I think they
can compete with every other high-end FPGA.
Luc
___
On Tue, 6 Jul 2004 21:18:17 +0000 (UTC), jhallen@TheWorld.com (Joseph
H Allen) wrote:
>Have any of you tried Lattice's software for their new -EC parts? How close
>is it to Xilinx (they share a common heritage)? I'm trying to get a feel
>for its quality and stability.
>
>Things should be getting interesting when their 90nm -SC parts come out (vs.
>Stratix-II and Virtex-4), especially with their cool DDR I/O interface.
>Perhaps Lattice will make a come-back?
Reply by Joseph H Allen●July 6, 20042004-07-06
Have any of you tried Lattice's software for their new -EC parts? How close
is it to Xilinx (they share a common heritage)? I'm trying to get a feel
for its quality and stability.
Things should be getting interesting when their 90nm -SC parts come out (vs.
Stratix-II and Virtex-4), especially with their cool DDR I/O interface.
Perhaps Lattice will make a come-back?
--
/* jhallen@world.std.com (192.74.137.5) */ /* Joseph H. Allen */
int a[1817];main(z,p,q,r){for(p=80;q+p-80;p-=2*a[p])for(z=9;z--;)q=3&(r=time(0)
+r*57)/7,q=q?q-1?q-2?1-p%79?-1:0:p%79-77?1:0:p<1659?79:0:p>158?-79:0,q?!a[p+q*2
]?a[p+=a[p+=q]=q]=q:0:0;for(;q++-1817;)printf(q%79?"%c":"%c\n"," #"[!a[q-1]]);}