Make sure M0~M2 are set correctly to read config flash at FPG
startup
Reply by Shreyas Kulkarni●May 5, 20052005-05-05
finding old archives might help you. i think there had been some
relevant discussions in past on this topic.
regards,
$hreya$
Reply by ●May 5, 20052005-05-05
I'm working with a Xilinx board (Spartan XC3S2000) and I can't program
Flash Eprom. I'm using iMPACT software. I have generated a
configuration file for Eprom and I load it on Eprom. But it doesn't
work. When I disconnect my parallel cable IV and set jumpers, my board
does not read eprom program. Can someone help me please? How have I to
set jumpers?