HB schrieb:
> Hi,
> 
> Do you have experience with nios2 and a specific terminal (hyperterminal,
> tera pro, or others) ?.
> I have problem to only have an easy printf message !!....
> 
> I 'm using Stratix(10) Altera Develop KIT with UART "console" DB9.
> I'm using example 'standart' (this example have an uart)
> In the Nios software I'm using example 'hello_word".
> 
> jtag_uart is OK,  I receive this message 'hello_word' in the NIOS IDE
> console.
> 
> How could I obtain this result with "uart" and a terminal.
> How can I do choices ('jtag_uart' and/or 'uart') to write this message ('IDE
> console' and/or 'terminal') ?.
> (for example options in properties of system library => std_out, std_err,
> std_in)
> 
> When I'm trying this example with UART, I have two result :
> 
> => if I don't connect first the COM of the terminal:
>          nios2-terminal: connected to hardware target using UART on
> /dev/com1 at 115200 baud
>          nios2-terminal: (Use the IDE stop button or Ctrl-C to terminate)
> => if I connect first the COM of the terminal :
>           nios2-terminal: can't open uart: Permission denied
> (So I'm using COM2 as terminal, and I connect the cable to this COM2, and I
> configure the properties of system library as COM1.  )
> 
> (no hardware problem with RS232 c�ble, loopback test is OK with pin 2 and 3
> of DB9).
> 
> Regards,
> 
> H.
> 
> 

check also niosforum.com

normal printf goes to stdout, this depends on the settings
in system library properties (stdout).
if a special device should be used then use
fopen("device_name") and fprintf(filepointer,...)
in your debug settings ( use Run-> debug... ) tab "Target connection",
"NiosII Terminal Communication device" and set it to the device the 
integrated terminal should use.
e.g. set it to none if you want to use hyperterminal.

Hi,

Do you have experience with nios2 and a specific terminal (hyperterminal,
tera pro, or others) ?.
I have problem to only have an easy printf message !!....

I 'm using Stratix(10) Altera Develop KIT with UART "console" DB9.
I'm using example 'standart' (this example have an uart)
In the Nios software I'm using example 'hello_word".

jtag_uart is OK,  I receive this message 'hello_word' in the NIOS IDE
console.

How could I obtain this result with "uart" and a terminal.
How can I do choices ('jtag_uart' and/or 'uart') to write this message ('IDE
console' and/or 'terminal') ?.
(for example options in properties of system library => std_out, std_err,
std_in)

When I'm trying this example with UART, I have two result :

=> if I don't connect first the COM of the terminal:
         nios2-terminal: connected to hardware target using UART on
/dev/com1 at 115200 baud
         nios2-terminal: (Use the IDE stop button or Ctrl-C to terminate)
=> if I connect first the COM of the terminal :
          nios2-terminal: can't open uart: Permission denied
(So I'm using COM2 as terminal, and I connect the cable to this COM2, and I
configure the properties of system library as COM1.  )

(no hardware problem with RS232 c�ble, loopback test is OK with pin 2 and 3
of DB9).

Regards,

H.