> Nju Njoroge wrote:
> > Hello,
> >
> > Is there an existing flow for simulating PLB DDR in ModelSim using EDK
> > 7.1 SP2 in a full system (PPCs, pcores,etc)? The instructions are being
> > stored in BRAMs, as to avoid DDR initialization hassles. I have been
> > simulating the data-only DDR using BRAMs, however, to get a more
> > accurate depiction of the system, I would like to use DDR in
> > simulation.
>
> Sure you can simulate that. Do you have the DDR memory simulation
> models? If not, Micron provides good models on their web site for the
> individual chips. Other than that, a specific question of what it is you
> are having trouble with would help; your question is too vague to me (or
> maybe I am overlooking something).
Thanks for the pointers. I'm trying to observe how my design interacts
with the PLB DDR Controller in simulation, but to do so, there needs to
be a DDR model with which the PLB DDR Controller can interface in
simulation. My design has a master PLB interface that issues writes and
reads to the PLB DDR controller. Previously, I have been using a PLB
BRAM controller, which I verified works in both simulation and in
hardware. However, I have been observing differences when I replace the
PLB BRAM controller with the DDR. Specifically, for certain test cases,
the design using the DDR controller doesn't work. Since my design
interacts with the PLB bus, I did not change it when I switched over
from the BRAM controller to the DDR controller.
Reply by Duane Clark●November 23, 20052005-11-23
Nju Njoroge wrote:
> Hello,
>
> Is there an existing flow for simulating PLB DDR in ModelSim using EDK
> 7.1 SP2 in a full system (PPCs, pcores,etc)? The instructions are being
> stored in BRAMs, as to avoid DDR initialization hassles. I have been
> simulating the data-only DDR using BRAMs, however, to get a more
> accurate depiction of the system, I would like to use DDR in
> simulation.
Sure you can simulate that. Do you have the DDR memory simulation
models? If not, Micron provides good models on their web site for the
individual chips. Other than that, a specific question of what it is you
are having trouble with would help; your question is too vague to me (or
maybe I am overlooking something).
Reply by Nju Njoroge●November 23, 20052005-11-23
Hello,
Is there an existing flow for simulating PLB DDR in ModelSim using EDK
7.1 SP2 in a full system (PPCs, pcores,etc)? The instructions are being
stored in BRAMs, as to avoid DDR initialization hassles. I have been
simulating the data-only DDR using BRAMs, however, to get a more
accurate depiction of the system, I would like to use DDR in
simulation.
Thanks,
NN