"Jon Beniston" <jon@beniston.com> schrieb im Newsbeitrag
news:1135448073.839625.134430@g49g2000cwa.googlegroups.com...
>
> leevv wrote:
>> No,
>> Ethernet MAC is hard core and it's free.
>
> But, be careful though, there isn't any s/w support for it in EDK yet.
>
> Cheers,
> Jon
>
Thanks Jon,
I was sure EDK supports the hardcore EMAC - but afer looking closer it seems
that there is no support in edk7.1 :(
any info if it is included in EDK 8.1 ? or is it coming in some EDK 8.1
service pack (like DDR2 support) ?
Antti
Reply by Jon Beniston●December 24, 20052005-12-24
leevv wrote:
> No,
> Ethernet MAC is hard core and it's free.
But, be careful though, there isn't any s/w support for it in EDK yet.
Cheers,
Jon
Reply by Marco T.●December 24, 20052005-12-24
"Marco T." <marcotoschi@nospam.it> wrote in message
news:doh7dp$ug1$1@nnrp.ngi.it...
> Hallo,
> I'm planning to buy a development board based on Virtex-4FX.
>
> I have read about V-4FX that ethernet mac is inside the FPGA.
>
> I should buy also the license to use it when I make a project into EDK for
> plb interface?
>
> Many Thanks
> Marco
>
>
Many Thanks to everyone for the replies.
Marco
Reply by leevv●December 23, 20052005-12-23
No,
Ethernet MAC is hard core and it's free.
Reply by Paul Hartke●December 23, 20052005-12-23
You don't need a special license to use the embedded Virtex4 TriMode
Ethernet MAC.
Check out Gigabit System Reference Design (GSRD) such an EDK project:
http://www.xilinx.com/gsrd/
Paul
"Marco T." wrote:
>
> Hallo,
> I'm planning to buy a development board based on Virtex-4FX.
>
> I have read about V-4FX that ethernet mac is inside the FPGA.
>
> I should buy also the license to use it when I make a project into EDK for
> plb interface?
>
> Many Thanks
> Marco
Reply by Marco T.●December 23, 20052005-12-23
Hallo,
I'm planning to buy a development board based on Virtex-4FX.
I have read about V-4FX that ethernet mac is inside the FPGA.
I should buy also the license to use it when I make a project into EDK for
plb interface?
Many Thanks
Marco