I can't say for the NIOS, but most of Altera's megawizard functions use
an active-high clear, not an active-low. I would suggest inverting (or
removing inversion from) the signal, and see if it works properly.
Reply by ●May 2, 20062006-05-02
Hi all,
I have a problem driving the RESET pin on a NIOS II processor. I expect
that when I pull LOW
this pin, the NIOS II processor makes a reset. But this is not true,
instead it reaches an
unstable condition.
Obviously, I make something of wrong, but where ? Do you have
experienced my same
situation ?
Best Regards
/Alessandro