Hello,
I would like to try the Ethernet Wrapper IP core together with the ml403
board and I have a problem making it operational. I have generated core
form generator after that update the constraint file so that all (I
think) RXs, TXs and PHY reset nets are connected to the pads. After
programing the FPGA I can see that PHY has been reseted and connection
has been established but when I send date to the board I have no
respond. In the example design which I'm using is loopback module which
connects TXs lines with RXs and makes address swapping so I should get
what I'm sending but in fact the board does not send anything.
Where I'm making mistake or what I haven't done which is necessary?
Regards,
Bartek