On 29 Dec 2003 10:46:52 -0800, symon_brewer@hotmail.com (Symon) wrote:

>James,
>Check out the input common-mode range (Vicm) and differential input
>voltage (Vidiff) for LVDSEXT_25. This should meet your requirements
>depending on the spec of the LVPECL parts you're using.
>Otherwise, you have to resort to level shifting resistors, or level
>shifting parts, try Micrel, Maxim, OnSemi etc.
>cheers mate, Syms.

I had a similar problem to the OP.  Unfortunately, no IO standard on
on the (2.5V powered) Virtex2 Pro had a common mode range suitable for
3.3V PECL.

My signal was DC balanced, so I capacitively coupled it from the PECL
to the FPGA, and used DCI to provide the DC bias and termination on
the FPGA side.

Regards,
Allan.

James,
Check out the input common-mode range (Vicm) and differential input
voltage (Vidiff) for LVDSEXT_25. This should meet your requirements
depending on the spec of the LVPECL parts you're using.
Otherwise, you have to resort to level shifting resistors, or level
shifting parts, try Micrel, Maxim, OnSemi etc.
cheers mate, Syms.

"jicho" <jicho@it.co.kr> wrote in message news:<bsgm6j$q69$1@news.hananet.net>...
> Dear all,
> 
> I am trying to use differential LVPECL interface on Xilinx virtex-II pro
> device.
> 
> I have to connect some standard LVPECL(3.3V) signal to virtex-II pro device.
> But I know that Virtex-II Pro devices support only LVDS_25 and LVPECL_25.
> There is no problem with Spartan-IIE or Virtex-II device because they have a
> LVPECL_33 I/O.
> 
> I want to know how I connect between standard LVPECL(3.3V) signal and
> virtex-II pro LVPECL_25 signal in differential manner.
> 
> Could anybody give me some answer ?
> 
> Thanks,
> james.

Dear all,

I am trying to use differential LVPECL interface on Xilinx virtex-II pro
device.

I have to connect some standard LVPECL(3.3V) signal to virtex-II pro device.
But I know that Virtex-II Pro devices support only LVDS_25 and LVPECL_25.
There is no problem with Spartan-IIE or Virtex-II device because they have a
LVPECL_33 I/O.

I want to know how I connect between standard LVPECL(3.3V) signal and
virtex-II pro LVPECL_25 signal in differential manner.

Could anybody give me some answer ?

Thanks,
james.