On Aug 14, 2:50 pm, "maxascent" <maxasc...@yahoo.co.uk> wrote:
> Hi
>
> I have designed an SDRAM controller and nearly ready to synth and P&R. My
> question is do I need to add any offset constraints to the ucf? I see that
> the Xilinx XAPP134 uses them but the newer DDR designs which are generated
> using MIG do not. Any info would be appreciated?
>
> Cheers
>
> Jon


It's important to constrain any timing that is critical to the SDRAM.
Normally you can use offset constraints to require outputs to switch
within a specified time of the input clock.  However in a design where
all of the outputs are constrained to use IOB flip-flops, there is
really no room for place & route to change the timing offset, unless
you're not using global clock resources.  This may be why there are
no offset constraints in the MIG.

Hi

I have designed an SDRAM controller and nearly ready to synth and P&R. My
question is do I need to add any offset constraints to the ucf? I see that
the Xilinx XAPP134 uses them but the newer DDR designs which are generated
using MIG do not. Any info would be appreciated?

Cheers

Jon