Reply by Mike Treseler●November 12, 20072007-11-12
Pasacco wrote:
> Could anyone tell me "how to set up the environment" (or, how to
> points to the location of the simulator)? in EDK 8.2 ?
Click up a shell, bash or cmd.exe
mkdir play
cd play
vcom
If this doesn't give you the vcom usage,
type "exit" to close the shell,
find vcom, and add it's location
to your path and try again.
-- Mike Treseler
Reply by Pasacco●November 12, 20072007-11-12
Dear
I need to simulate my EDK (8.2) project.
Simulator is Modelsim SE 6.1c.
I did following steps:
-------------------------------------------
In order to compile COMPXLIB,
I used the EDK simulation library compilation wizard
Project -> Project options -> HDL and Simulation -> Simulation library
path
EDK library = C:/EDK/EDK_LIB
Xilinx library = C:/Xilinx/Xilinx_LIB
-------------------------------------------
However, I could not proceed, because of the message "Modelsim is not
found. Please ensure that the simulator is correctly installed and/or
necessary environment settings are available".
Could anyone tell me "how to set up the environment" (or, how to
points to the location of the simulator)? in EDK 8.2 ?
Thank you in advance